What gallery glass is
Gallery Glass is a brand of water-based faux stained glass paint and liquid leading. “Faux” means the look is stained glass but the method is painting. You do not cut or solder anything. The paint and leading go onto clear glass, acrylic, or peelable clings, and the piece air-dries.
Gallery glass suits suncatchers, window panels, decor, and clings. It is not kiln-fired, so it is not the same as traditional glass painting. For that difference, read what is painting on glass called?
What you need
- Gallery Glass paint in the colors you want, and liquid leading for the outlines
- Clear glass or acrylic sheet, or a clear cling sheet
- A printed pattern with bold lines
- Paper towels, a toothpick or stylus, and a pin for popping bubbles
- Tape to hold the pattern in place
- A flat, level surface where the piece can dry undisturbed
Prepare the surface
Clean the glass or acrylic with glass cleaner and dry it fully. Oil, dust, and fingerprints can make the paint pull away or peel later. Handle the piece by its edges.
Decide which side will face the viewer. Some projects are painted on the side that faces the room, and others on the reverse. Check the instructions for the piece you are making, since the viewing side changes how the leading and paint look.
Trace the pattern
Place the printed pattern under the glass or acrylic and tape it down. Trace the lines with liquid leading. Keep the pattern simple at first, with large sections and clear lines. Fine detail is hard to outline evenly until you have practiced.
Outline with liquid leading
The leading is the black or dark line that separates each color, like the lead in a real window. Work steadily:
- Hold the bottle upright and just above the surface.
- Press lightly to start the flow.
- Move at a steady pace and let the leading fall into place. Avoid dragging the tip across the glass.
- Tap the bottle down gently to keep the flow even.
- Keep each line continuous. A gap in the leading lets paint run into the next section.
Practice on scrap glass until the lines are even. Then let the leading dry. Most products need several hours, and overnight is the safe choice. Painting over wet leading can smear the lines or let color bleed across them.
Fill the color
Roll each paint bottle between your hands or on a table rather than shaking it, which helps keep bubbles out. Test colors on scrap glass first, because wet paint often looks different from dry paint.
Fill each section so the color reaches the leading lines, with no gaps at the edges. Apply the paint in even layers. Very thick areas take longer to dry, so avoid heavy blobs in one spot. Work one section at a time so wet paint does not cross into the next.
Remove bubbles and smooth the surface
Bubbles rise to the surface and stay there as the paint dries. To remove them:
- Tap the back or underside of the glass gently so bubbles float up.
- Pop stubborn bubbles with a pin or toothpick.
- Smooth the surface with a toothpick while the paint is still wet.
Stop once the surface is smooth. Overworking wet paint can move it into the leading.
Texture effects
A toothpick or stylus drawn through wet paint blends shades and makes soft swirls. For a textured privacy-glass look, scribble clear paint in loose circles and let small gaps show through. Try these on scrap glass before you use them on a finished piece.
Curing and handling
Gallery Glass paint takes time to cure. It usually skins over in about 8 hours and dries through in about 24 hours. Thick areas can take up to 72 hours. Keep the piece flat, level, and away from dust while it dries, and do not touch or wet the painted areas until it is fully cured.
For a full timeline, read how long does gallery glass paint take to cure?
Troubleshooting
- Color bleeds across the leading. The leading was probably not dry before you painted. Let it dry longer next time.
- Bubbles stay in the paint. Tap the back of the glass sooner, and pop bubbles while the paint is still wet.
- Gaps at the edges. Fill the color closer to the leading lines. If the product’s instructions allow it, add a second thin coat once the first is dry.
- Milky or cloudy finish. Moisture is still in the paint. Give it more time in a dry room with gentle airflow.
- Paint peels. The surface may not have been clean. See which paint will stick to glass? for prep tips.
Clings vs window projects
Clings are painted on a clear sheet, then peeled off and stuck to a window. Let them cure fully before peeling. Peel slowly, and check the product’s instructions for re-sticking.
Window projects are painted directly on glass and stay in place. Wait for full cure before cleaning them, and wipe them gently.
Gallery glass decor is not meant for food or drink contact. Keep it on windows, jars used for display, and other decorative items.
For more on what faux stained glass is compared with real stained glass, see the stained glass techniques overview and how to tell real stained glass from imitations.